gannongs
New Member
Hey all,
First time post. Looking to do some upgrades on my 2012 NC700x. Bought a Kaoko Throttle Lock. Things were going fine on the install for about 2 minutes. Then I ran into the problem of removing the handle bar insert via prying the spring tabs.
For the life of me I cannot get this center piece out. The screw is there for something for a friend to pull on while I push the spring clamps inward. Any ideas? Am I missing something completely stupid?
I have shot a bunch of WD-40 down on it a few times but still no results.
Help! Please!
First time post. Looking to do some upgrades on my 2012 NC700x. Bought a Kaoko Throttle Lock. Things were going fine on the install for about 2 minutes. Then I ran into the problem of removing the handle bar insert via prying the spring tabs.
For the life of me I cannot get this center piece out. The screw is there for something for a friend to pull on while I push the spring clamps inward. Any ideas? Am I missing something completely stupid?
I have shot a bunch of WD-40 down on it a few times but still no results.
Help! Please!