LiveInTheMoment
Member
Drilling Question
For someone who knows zilch about drilling, exactly what tool do you use to drill these holes? With the 20" screen, mine is in the lowest position but I would like to lower it 1 more inch...maybe I should've gotten the 18".
I don't know how Madstad is mounting the shields on the new brackets, but on the old ones they consistently mounted the shields too high, IMO. I ordered my 20 inch shield un-drilled and mounted it 1 3/4 inches lower than Madstad would have done. I look over the shield at the low position. All the air blows over the top of my helmet.
So, if you decide to go to a 22 inch, you might drill it 2 inches higher, so the shield sits 2 inches lower. This will give you the same upper coverage but close off that bottom gap that directs wind at your neck. Even if you mount it lower than stock, you'll still have plenty of height if/when you raise it on the sliding brackets
For someone who knows zilch about drilling, exactly what tool do you use to drill these holes? With the 20" screen, mine is in the lowest position but I would like to lower it 1 more inch...maybe I should've gotten the 18".