Rydinon
Active Member
I wear a Helite Turtle2 airbag vest as part of my ATGATT. Generally speaking, one wraps the Helite tether around the frame at the front of the seat and then brings the strap up between the tank and the front edge of the seat. Snap the tether to the vest and you are good to go. For those who are not familiar with the vest, a 60 lb pull on the vests lanyard is required to puncture the CO2 cartridge for inflation. The best location for the tether is front right since the vest's lanyard is just right of center.
Where did you attach the tether?
My '21NC has no visible frame in this area. It does have a piece called the Center Cross Plate (CCP)* immediately aft of the frunk. The front tongue of the seat fits into a pocket in the center of this plastic plate, and a rubber shield overlaps the CCP. If I wrap my tether around the right hand base of the CCP, it will distort the right hand flap of said rubber cover. I think this is part of the battery shield to keep water away from the fusebox, battery compartment. Can anyone confirm this? Any alternative anchor points for the tether?
*relax, this abbre. is not for the Chinese Communist Party
Where did you attach the tether?
My '21NC has no visible frame in this area. It does have a piece called the Center Cross Plate (CCP)* immediately aft of the frunk. The front tongue of the seat fits into a pocket in the center of this plastic plate, and a rubber shield overlaps the CCP. If I wrap my tether around the right hand base of the CCP, it will distort the right hand flap of said rubber cover. I think this is part of the battery shield to keep water away from the fusebox, battery compartment. Can anyone confirm this? Any alternative anchor points for the tether?
*relax, this abbre. is not for the Chinese Communist Party