MtnBkr47
Member
Most of the time my new DCT worked normally, but Occasionally at a stop light, etc, it would not switch into Neutral.... never a problem with Drive fortunately, and the kickstand switch works. If I turn it Off and restart, I could once again get into Neutral just fine. Only 1300 miles on the bike. After reading some of the great info here, I checked my battery connections and voltage (all OK), my idle RPM is normal at 1200, throttle slack normal, and my oil is OK. I did a DCT reset calibration and it took 4 tries to achieve success, but all is normal so far. I wondered if this had happened because a forgot a couple times and shut my engine off before I had switched into Neutral. Is this problem something that happens much, and is there a reason for it... something to worry about?