Hyperborea
Member
I'm in the middle of installing some extra lighting (Skene photon blasters in amber with signal) and I'm looking to tap into the turn signal wiring harness. I've got it opened up and I can see 6 wires where the wiring schematic is showing 4. I've got to the left signal: Green, Orange, Orange w/ White; and to the right signal: Green, Light Blue, Light Blue w/ White.
I think that Green is ground and Orange and Light Blue are the signal power. What are the Orange w/ White and Light Blue w/ White wires?
Also, for power for the Skene LED controller would you stretch the wiring out to the accessory sub-harness or is there something closer to use? If I use the sub-harness I'm going to have to tap it with posi-taps anyways since I don't have the right connectors. I can order them (found them online) but it will take a while to get them and I was planning on finishing and buttoning everything up tomorrow.
Thanks
I think that Green is ground and Orange and Light Blue are the signal power. What are the Orange w/ White and Light Blue w/ White wires?
Also, for power for the Skene LED controller would you stretch the wiring out to the accessory sub-harness or is there something closer to use? If I use the sub-harness I'm going to have to tap it with posi-taps anyways since I don't have the right connectors. I can order them (found them online) but it will take a while to get them and I was planning on finishing and buttoning everything up tomorrow.
Thanks