muffintop
Member
Hey inmates,
I have a 2013 NC700X. I intend to install Barkbusters handguards. I watched a video of the install as well. As per the install instructions, I am trying to get the handle bar endweight off. I was able to roll the grip/sleeve and see the clip. I am able to press the clip, that is barely visible. For the life of me, I cannot pull this out. Can this clip be squeezed from the end of the sleeve, or is there another point for the clip somewhere deep inside the sleeve? My mechanic squirmed at this job, and said it would cost me $90 in labor. Any tips, or pointers greatly appreciated.
I just found another video where he just destroys the clip. How To Remove Honda Bar Ends and Cores - YouTube
I am not removing the grip/sleeve completely. Is that needed?
-MuffinTop
I have a 2013 NC700X. I intend to install Barkbusters handguards. I watched a video of the install as well. As per the install instructions, I am trying to get the handle bar endweight off. I was able to roll the grip/sleeve and see the clip. I am able to press the clip, that is barely visible. For the life of me, I cannot pull this out. Can this clip be squeezed from the end of the sleeve, or is there another point for the clip somewhere deep inside the sleeve? My mechanic squirmed at this job, and said it would cost me $90 in labor. Any tips, or pointers greatly appreciated.
I just found another video where he just destroys the clip. How To Remove Honda Bar Ends and Cores - YouTube
I am not removing the grip/sleeve completely. Is that needed?
-MuffinTop
Last edited: