belrix
Site Supporter
In my never ending quest for the next frakle I've decided to install a set of fork gaiters on my NC700X and have a question about the process.
I know I need to remove the fender, front wheel and caliper, then loose the tripe-tree one side and a time, slide down the fork tube, install the gaiter, then side the fork tube back up and tighten, then repeat on the opposite side.
How do I know the fork tubes are aligned correctly, both side to side and up and down?
I apologize if this is an obvious question!
belrix
I know I need to remove the fender, front wheel and caliper, then loose the tripe-tree one side and a time, slide down the fork tube, install the gaiter, then side the fork tube back up and tighten, then repeat on the opposite side.
How do I know the fork tubes are aligned correctly, both side to side and up and down?
I apologize if this is an obvious question!
belrix