GoRovers
Member
Today I received and installed (on my 2016 NC700XD) the 20" Madstad windshield (light grey). The instructions say, "Nudge the (Phillips truss) screws into the well nuts then screw them in until they are snug, which means the screw tip has gone slightly past the back of the well nut. Do not overtighten!"
This photo shows I'm "slightly past," however the screw still turns very easily. Should I tighten the screws a bit more? The windshield feels secure, but I don't want to lose a screw (or the windshield) mid-ride.
This photo shows I'm "slightly past," however the screw still turns very easily. Should I tighten the screws a bit more? The windshield feels secure, but I don't want to lose a screw (or the windshield) mid-ride.