Check engine light on - Code 9-2 "IAT sensor voltage high"

[Dollar Bill]

After installing the Honda accessory fog light kit on my 2013 NC700XD (has under 7,000 miles) the check engine light began blinking.
The dealer found fault code 9-2 indicating an IAT sensor high voltage condition. The bike runs fine and the check engine light was not on prior to my installing the lights.
I will look for loose connectors, but can anyone suggest a repair? Also, is there a way to clear the fault code and reset the check engine light without returning to the dealer?
Thanks for any help you can provide.

 

[showkey]

Th most common cause of IAT high voltage is............the sensor is unplugged. Most common spot for the unplug is at the air box lid at the sensor itself.

 

[Dollar Bill]

Th most common cause of IAT high voltage is............the sensor is unplugged. Most common spot for the unplug is at the air box lid at the sensor itself.

Thanks for the quick reply, Showkey. I'll check this and post my success (hopefully).

 

[Dollar Bill]

That was the problem...I had forgotten to re-connect the IAT sensor plug...doh!
Thanks again for your help!