Search results

Used rack is sold btw, thanks!

Hey guys I'd like to actually sell back one of the rear racks with fuel hole I got a little over 2 years ago. I actually had to ship the bike abroad and chose to keep the rear seat for passengers so I've got this rack left here in Chicago If anyone's interested PM me, it's got some scratches...

Ah well darn... where might I find one of these testers? My dealership is way out in the suburbs so it's tough to get to them. Is it something like this: Diagnostic Tester for Honda Acura Honda HDS Diagnostic System Kit | eBay ? Thanks!

Thanks all for the replies! Ok will do, any OBD2 code reader will do correct? Thanks!

Hey all, Been getting some issues with ABS recently, light comes on, transmission starts to fail... How might I find out if it's either of the ABS sensors that are faulty? What kinds of resistance values should I be expecting when measuring with multimeter? Thanks!

That's awesome, I was considering those as well, any plans on installing them soon?

Yes I went for a longer shock, however due to the diameter of the spring I was not able to get the full 1.8" raise I wanted. It can only go as far as about 1.2" or something like that.. tough to measure. I would say that a shock meant for an extra inch AND a shorter shock link would be ideal

Alright well I got 3 responses between 138lbs and 155lbs. Honda says the DCT model is 26lbs heavier, so 164-181 lbs for that one. I'm actually surprised, I figured more of the weight was from the engine block.. that represents only %30 of the fully fueled weight of the bike. FYI: Engine oil is...

Oh indeed great idea thanks!

Hey all, does anyone have an idea of how much of the total weight of the bike is the engine & transmission block (with oil)...? Or even better, the actual weight? Thanks!

Oh I see awesome! I did not realize the switch was connected to a motor to pull the cable hehe. Yea I was hoping for a simple mechanical push lever (: Can't seem to find any of those online though /:

Thanks for the info! THis switch? RP8200B2M1CEBLKBLKRED E-Switch | Switches | DigiKey Isn't this an electric switch though? Shouldn't we be looking for mechanical action instead?

Awesome! Would you be able post a link to the switch or the name? All my searches to ebay or amazon only show electronic switches... Thanks!

Hey all, My frunk lock has been working really bad and spraying some PB Blaster isn't getting it all the way clean either. I've taken the whole thing apart, cleaned and rebuilt but it seems the key section/assembly itself is bad... I can still open it but it tends to bend my key...

oOo good call I might be able to get one of those.. if I can convince them to ship just that piece ha

Sure! Front fork 1" extension, front tire with an additional 1.8" in diameter, and rear shock rear travel increase by 1.9"... so essentially 1.9" ground clearance increase.. I may tweak this a bit when it actually happens and decrease it, since I think the front tire will fit ok (with the engine...

Hm nice, hadn't thought of just sticking something at the end hah... I'll probably start with that and see if it works out. Otherwise I might just cut it and extend it with some aluminium or metal tube. THanks!

I was thinking about that but I don't think it would be enough... with an extra 1.5" off the ground, the current kick stand would barely touch the ground below the bike hah, bike would be leaned way over and the stand would be pointing straight down...

Hey all, Any ideas where I might find a slightly longer kickstand for the NC? I'm raising it by 1.5" and am going to need something a little longer... Thanks!

Hey peeps thanks for all the awesome info! Quick question: if I were to use a longer shock, what would be the first issue I would run into if it were too long? Would it be the the shock spring touching the mounting point on the swingarm at full extension? Theoretically, how long should I have...