dirtbikes987
New Member
the other day I rode into work and along the way I feel like the bike started to shutter and out of the corner of my eye I think I saw all of the lights on the dash flash. I pulled the clutch in and revved the bike and everything seemed fine so I continued into work. When I was done at work, I went out to the parking lot, put the key into the ignition and turned the key to run. The lights on the dash flashed, the display came up and the fuel pump kicked on like it all should, and then everything just went dead. I turned the key on and off a couple of times and nothing. So, I removed everything from the frunk, removed the battery and checked all of the fuses and everything looked ok so I put it back together and it fired up perfectly and I went about my way home with no problems.
So, as I read some other posts on here I may have found my problem but wanted to run it by some others. Over the winter I installed some LED aux lights and heated gear that I wired in to a secondary fuse block that I have jumpered off of the key switch. I initially had everything run right to the battery but didn't want to accidentally leave the lights or drain the battery so I changed it to be off of the ignition circuit instead. Right now I do NOT have a relay installed on that circuit. Is that my problem?
thanks
So, as I read some other posts on here I may have found my problem but wanted to run it by some others. Over the winter I installed some LED aux lights and heated gear that I wired in to a secondary fuse block that I have jumpered off of the key switch. I initially had everything run right to the battery but didn't want to accidentally leave the lights or drain the battery so I changed it to be off of the ignition circuit instead. Right now I do NOT have a relay installed on that circuit. Is that my problem?
thanks
Last edited: