Juan_Banjovy
Active Member
It's on but it doesn't completely fold up. There's a rubber piece that's supposed to stop on a metal tab on the exhaust. It doesn't. Because that triangle shaped hoop hits it first. The hoop is where the springs hook onto. So the question is, saw off part of the tab or try bending the hoop out of the way? It would work like this but would likely reduce lean angle a lot. Pic: That round rubber piece should contact the steel tab above it when the stand is up. I haven't put the springs on that hoop yet. NOTE: This center stand is for the Honda NC700S which is lower because I'm installing lowering links next. This stand may be a little different than the NC700X stand.
Last edited: