Need dimensions of preload spacer in the forks

Last night I installed a set of Cogent Dynamics drop in cartridges in my NC700X forks. Pics and review to follow when I get some miles on the massaged forks.

However when got it all back together last night and measured sag I missed my target sag by 7 mm and have to make a longer set of preload spacers to get there. Honda calls them spring collars. I was so sure I did my math right I did not measure the stock ones which is going to be the starting point.

Does anyone have the length measurement of the stock spacers?

I still have my stock spacers in the garage. I went with the R.T. valves and springs, so I used their supplied spacers. I'll measure them in a few minutes.

Sent from my SM-G900V using Tapatalk

Thanks! I have the OD but not the length.

Looks like 150mm.

If this is what you were talking about.

Sent from my SM-G900V using Tapatalk

Yes, that's what I needed. Thanks!

No problem! Glad to help!

Sent from my SM-G900V using Tapatalk