Search results

potterOo, Thanks for the quick reply. But I ment the "other" throttle body where the fuel injection takes place where the throttle cables end up on opposite ends of the twist grip. Needed to get in there to get some more slack in the cables to remove them from original grip. I tore into the...

how to get to the throttle body???? I'm installing heated grips now and need to get to the throttle body to loosen the cables. Where is it at and how do I get in there???? Thanks Rob

rack purchase Dale , I would like to purchase your rear seat rack with the fuel hole cut out. I'm in Walla Walla, WA. How do we go about ordering it? thanks, Rob

On my 2012 NC700x, I zero both A and B trip meters when going on a trip. Then just re zero A at each fuel stop to check fuel mileage. I leave B alone but on trips B has re zeroed itself and I lost how far I actually went on the trip's total miles????? So now I just write down starting and ending...

I was wondering about cutting a round or square hole in the flat plastic piece thats under the trim piece that we take off on the frunk end that we could drop in a small plastic round or square tub into with a snap on lid. Lid would hold it from falling through and it would be more waterproof. rj

Well I'll be. I just took both sides off and they are equally unfilled. So what do we call these storage areas? We have a frunk, how about "fents" for false vents or "fides" for false sides? rj

Thanks L.B.S. What about the other side as it looks fake also? rj

I've read of people storing things in the fake air vent on the NC. Where is this and how do you get in it? I don't have a owner's manual as previous owner has yet to come up with it. So other then looking at the bike I'm not seeing any scoops other then the 2 below the front blinkers and they...

For drilling plastic use drills made for glass from Home Depot that look like a shovel spade. Or take a small india stone and stone a flat on the very front of the cutting edge of a regular drill. That will keep the drill from screwing into the plastic as it cuts through the other side and...

If I lower the forks and seat 1" does the very bottom of the bike loose 1" of ground clearance? Or does it not work that way because of the linkage? I'm thinking of lowering my NC700 but want to keep an eye on the ground clearance if I go off road a bit. Thanks, Rj

I can confirm riding with Tom over in Kamiah, ID last weekend at the Happy Trails Rally and he was on his new NC700x that was yellow and black. Nice looking bike, rj