A few people have been scammed on the site, Only use paypal to pay for items for sale by other members. If they will not use paypal, its likely a scam NEVER SEND E-TRANSFERS OF ANY KIND.
I saw your post and it made me think. I just went to the Triumph dealer and a similar epiphany. I went in because they had a new 2013 Bonneville that was a left-over. It was gorgeous and shiny and well, a triumph bonneville. The dealer set me up with a test drive and while I'm sure its the...
So I discovered the other day that if you're not paying attention and gun the throttle on your bike you can ever so gently smash the windscreen and break/crack the instrument stay. Sure, the stay looks pretty durable, but apparently not as durable as the side of the parking garage. The...
Yep, its awesome but its unavailable in the US. The only available airbag vest is the hit-air one which uses the tether system which is significantly slower than Daineses. I keep watching to see when Dainese starts selling the d-air street system, I'll be in line for it. very cool, very smart.
Just installed the Barkbuster Storm handguards on my bike last night. Used the barkbuster hardware and pulled the OEM weights out. Now I think I'm getting a vibration in the throttle grip, could I be right? Never one to think ahead, I read this thread after I pulled the weights and may go...
Interesting.....
I'm racking my brain but can't figure out why this isn't a good idea. I agree the rack system is probably the preferred method. I like this one as well, the Dewalt system looks like a poor man's pelican case.
Great idea, let me know how it progresses!
Thanks guys, I really appreciate the posts, incredibly helpful. They are now secured up under the top case and look pretty good. Not as cool as Draco's silver clamp but not bungee corded to the side either. Thanks again!
They're three by fourteen. I built one up at four diameter but it was so big I wasn't sure how to hang it. Also it looks like I'm attaching a bazooka to the side of the bike so I went a little smaller. Three or four is all home depot sold. I'm going to REI tomorrow to find a smaller fuel...
Anyone have any advice on placement of tool tubes without pannier racks? My bike gets to the empty warning too quickly and I'd like to push my luck a bit and see where bottom is on the fuel tank. So I made the below tool tube but am kind of stuck on placing it. Anyone installed one without...
Maybe an airhawk seat pad if you are going to spend alot of time on it. I commute on mine and that pad is the best compromise between the stock seat and the pretty expensive aftermarket replacements. Enjoy the bike!
Did you notice any kind of new vibration upon installing the givi bars? I put mine on this week and there seems to be a bit of a vibration. I looked around the web and other forums complain about vibration from the bars on other bikes like the V-strom. They've come up with a lot of fixes...
OCR,
Did you notice any kind of new vibration when you installed the bars? I've read about givi bars and sw-moto bars creating a new vibration on other bikes, like the v-strom. I was just curious if anyone has the same experience?
I know this is an older thread but I just wanted to thank you. Spent last night putting these bars on and geez!!! I hope Givi doesn't do instructions for any medical procedures. Those were the worst instructions ever and I was at wits end until I found this thread. I'm ordering the...