A few people have been scammed on the site, Only use paypal to pay for items for sale by other members. If they will not use paypal, its likely a scam NEVER SEND E-TRANSFERS OF ANY KIND.
I DO want to make the bike a brighter color... i was thinking either plastidip(would be quite a bit of work to get all the pieces off) or vinyl wrap.
Any other ideas?
Peter
Hi Beemerphile.
i hope your eye heals on its own. get some rest, that usually is good for ailing body part.
i know that your bike's entire front end is apart right now, but do you know roughly how much work is needed from a fully assembled bike to get the headlight housing out?
Peter
Are there any fork sliders out there for the NC700X? I am a first time rider, and want to add as many "protection" items as possible. I already have my eyes on a set of GIVI Engine guards, R&G bar end sliders, R&G swing arm spools for service stands that also acts as a rear axle slider...
That picture may be wrong, but Hepco & Becker does make a side carrier for the NC700X. The part number also matches what Hepco-Becker.de site shows. It SHOULD be fine...
http://neu.hepco-becker.de/Montageanleitungen/650973.0001.pdf
Peter
Yah, you shouldn't complaint at 6699... because us west coasters are paying full msrp plus dealer fees..... The lowest around Los Angeles area is about $8200 out the door. A forum member here is actually flying down to Oklahoma to pick up an NC700x. After the cost of the trip, etc, he'd still...
I was quoted $8300 OTD from mid-city motorsports in paramount (near the 605/105/5). I did not negotiate at all, but just casually asked for the price. If you haggled, i'm sure the price can come down some, although I don't know how much.
Anyone else got a better price in the Los Angeles Metro...
Did anyone get a NC on US west coast? Specifically southern California. I am looking to get one in the next month or so, and am curious to see what I should expect to pay. If anyone who has gotten one can share his experience, I would greatly appreciate it. Thank you.
Peter