Honda NC750x ‘18: Tapping into wire for Denali DataDim Dual Intensity lights

[Gazza732]

I have a set of Denali D4s and looking to install on my Honda NC750X. I know the headlights are LED and don’t think the high beams use a 12v to change from low to high beam. Has anyone figured out how to make the D4s work with the stock low/high beam switch? I have the DataDim module so all ready, just need to install. Any help greatly appreciated as somewhat new to this.

 

[Hank]

I did not do the wiring myself, but my Denali D2s were installed like:

battery to harness to Denali off/on switch to motorcycle high low switch.

The result is I can turn them on and off, dim them, and they stay on when I switch to high beam.

Lights shown at 2:18.

Honda NC700x DCT Additions and modifications. Oklahoma Hank. - YouTube

 

[Gazza732]

I did not do the wiring myself, but my Denali D2s were installed like:

battery to harness to Denali off/on switch to motorcycle high low switch.

The result is I can turn them on and off, dim them, and they stay on when I switch to high beam.

Lights shown at 2:18.

Honda NC700x DCT Additions and modifications. Oklahoma Hank. - YouTube

Hello and thanks for the post.

This seems like a good start to look into. I've got all the stuff that come with the lights (harness, on/off switch, lights) and then the separate datadim module that I've added to the harness pre-install. Would you have any idea where I start with that as there is a set of instructions so not sure how much or if I'll need to deviate?

Really appreciate your time. Thank you.