Your axle at the clamp looks fine. It looks like mine. Attached is a picture I took moments ago. Also, I seem to remember from a previous discussion that the two front spacers are the same size, so you couldn't mess up by swapping them. Verify with a parts listing..I am still confused.. RT gives 120 mm and stock 104 mm, measured from the top to oil level - So more air would be with RT setup, right? At least before installing the spring..
I am afraid I bent something while replacing the seals.. When I was putting valve on top of the rod on one side it did not look centered and after installing the forks back they seem too wide on the bottom.. There is a gap between spacer and a fork after installing the wheel..
View attachment 44854