Search results

  1. L

    nc700 rear rack

    I sent him a PM and an email about a week ago and haven't heard anything yet. Hope he's OK.
  2. L

    Ordered Spiegler Stainless braided Brake Lines

    Would not be the same. ABS models have more lines with different fittings.
  3. L

    Information Can’t find a definitive answer

    I have my X lowered 2 inches in back and almost an inch in front. I am using an S version side stand and centerstand.
  4. L

    Extended Warranty or No Extended Warranty, that is the question.

    If it was me, I would wait. I believe you have until the factory warranty is about to expire to purchase it. It may be that you change your mind in a year and decide you want something else. That said, although the DCT is very reliable, given the complexity, I would buy the extended warranty...
  5. L

    Unsure about buying the NC750X, need advice.

    No heat here. The motor has a pleasant throb to it. Not harsh or buzzy.
  6. L

    NC700X Stock windshield removal

    I run with no windshield all summer. Only put on a windsheild once it starts to get cold. I like the smooth quiet airflow around my helmet.
  7. L

    2" risers for the NC750X

    I have 2 inch rox risers on my 2012 DCT ABS and initially had the same problem. There is a bracket and grommet that holds the brake line farther down on the frame. I had to remove that. From your video it looks like you have already done that. The second step is to reroute the brake line to...
  8. L

    Adding bar rise beyond 2"

    Outstanding work. I have 2 inch rox risers on my DCT but I need more. I was planning on using CTX cables and seeing if the CTX brake line might help. I planned on checking if could reroute the switch wiring behind the triple clamp for more slack. If not I may attempt to source the connectors...
  9. L

    Cogent DDCs installed - and I can't tell a difference

    I had the same experience. Couldn't tell a lot of difference. Put it back to stock with fresh oil and careful assembly and its actually more compliant than the DDC's. I think the issue is that the stock compression damping hole in the damping rods is too small to let the emulator perform like it...
  10. L

    mystery connector front left

    5v would have to be for some type usb charging application, say phone charger?
  11. L

    Ordered a Corbin seat this morning for my NC750x

    Where did you get the longer throttle cables?
  12. L

    Best Polycarbonate Windshield

    They are barkbusters. They do not interfere but I do have Rox risers set pull the bars back towards me. (I have short arms)
  13. L

    Best Polycarbonate Windshield

    2008/MRA pics Pics of the 2008/MRA Combo.
  14. L

    Best Polycarbonate Windshield

    With the 2008/MRA Combo I am looking over the the windscreen. You can adjust the MRA height and angle to suit. I have it set so I am comfortably looking over it also. I can also look over the 2009 but just barely. I currently have a couple spacer under the lower mount to tilt the screen a little...
  15. L

    Best Polycarbonate Windshield

    I have the 2008. I also have the 2007 and 2009 screens so I have tried them all. For reference I am 5'8" and 30" inseam. The short screen puts a lot of turbulence and noise at about nose level. With the 2008 and 2009 I have less noise and turbulence but they are still there. The 2008 and 2009...
  16. L

    Knight Designs lowered pegs FS

    PM sent on pegs
  17. L

    Saddlemen seat for 2012-2015 nc700x

    Sold Seat is sold.
  18. L

    Saddlemen seat for 2012-2015 nc700x

    They come as a kit you have to install on your stock seat pan. The kit is a little over $200. I had a professional shop install it and they charged me around $100 for both the front and rear. There is less slope I think but still some. I think all the aftermarket seats may have some slope to...
  19. L

    Altrider skid plate

    Sold Skid plate is sold