Search:

Type: Posts; User: 670cc

Page 1 of 20 1 2 3 4

Search: Search took 0.08 seconds.

  1. Replies
    6
    Views
    117

    Agreed. Sort of. "Opening them up" involves...

    Agreed. Sort of. "Opening them up" involves pushing the pistons back to create clearance for one pad. It also involves sliding the caliper on the pins to create clearance for the other pad. If you...
  2. Replies
    6
    Views
    117

    The pistons are only on one side behind one pad. ...

    The pistons are only on one side behind one pad. The other pad goes on the opposite side, or the frame of the caliper. The whole caliper has to slide laterally on the pins attached to the caliper...
  3. Replies
    10
    Views
    272

    It's not very pretty, but I think it would be way...

    It's not very pretty, but I think it would be way more functional than any typical hugger design. You're right, it's not clear how it's attached. Pyramid's front Fenda Extenda attaches with double...
  4. Replies
    10
    Views
    272

    It might protect the shock from some direct...

    It might protect the shock from some direct blast.

    The negative aspects:
    It's short, so it won't offer much protection.
    Also because it's short, the rear wheel will still toss debris up on...
  5. Thread: Muffler swap?

    by 670cc
    Replies
    18
    Views
    1,663

    Unless the stock exhaust (new or old style) is...

    Unless the stock exhaust (new or old style) is also included in the sale, any used bike for sale with an aftermarket exhaust is immediately struck off my list. Sell the 2017 with the 2012 can. If the...
  6. FS: HONDABIKEPRO Skidplate, for NC700X manual trans

    For sale is a used HONDABIKEPRO skid plate that fits manual transmission 2012-2015 NC700X. I had it mounted on a 2012 model. It may or may not fit on a 2016+ NC700X/NC750X, but I have no way to...
  7. Replies
    8
    Views
    287

    Yes, my 2012 is still for sale! Thanks, David,...

    Yes, my 2012 is still for sale! Thanks, David, for posting the link to my ad.
  8. Replies
    1,610
    Views
    295,223

    Sticky: I had to chuckle, imagining a picture with an...

    I had to chuckle, imagining a picture with an animal that matches the lime green color of my NC. If I could get a parakeet to sit still on my bike, that might be pretty close.
  9. Thread: Forum problems?

    by 670cc
    Replies
    56
    Views
    3,253

    Since about December 2 or 3, I’ve been having...

    Since about December 2 or 3, I’ve been having forum problems. There were a few instances where the server was unavailable during that time, so I wonder if there were software changes done. I’ve PM’d...
  10. Replies
    24
    Views
    857

    But the risk for problems is high. Maybe the...

    But the risk for problems is high. Maybe the financing somehow gets screwed up, your credit report becomes a mess, your personal data is sold (“shared”) by the finance company, and every other bank...
  11. Replies
    5
    Views
    85

    I’m sure the ‘18 is a fine machine, but that’s...

    I’m sure the ‘18 is a fine machine, but that’s what I mean, I’m not the target audience. On my ‘02, I’ve probably used the radio a whole 10 minutes in the 15 years I’ve owned the machine. I have...
  12. Replies
    24
    Views
    857

    Ditto on the cash penalty. I got a quote for an...

    Ditto on the cash penalty. I got a quote for an RV once and I was told I would have to pay $3000 more if I wanted to pay cash. I walked away, but jeez, what’s the world coming to?
  13. Replies
    26
    Views
    527

    Thanks for that verification. It’s stuff like...

    Thanks for that verification. It’s stuff like these fake reflectors and also a light kit that won’t fit correctly that makes me have to downgrade my opinion of Givi products.
  14. Replies
    7
    Views
    1,358

    A fuel pump cutoff would not cause any damage...

    A fuel pump cutoff would not cause any damage beyond eventually running down the battery during the start attempt.

    I wonder how many bike thefts actually involve starting the engine. I understand...
  15. Replies
    5
    Views
    85

    I noticed that Honda of Russellville, Arkansas...

    I noticed that Honda of Russellville, Arkansas has 14 of the 2018 Goldwings in stock at this time. It seems maybe there is a lot of unsold old stock of the new 1833cc version of the Goldwing. Perhaps...
  16. Replies
    26
    Views
    527

    The mention of reflectors on the V35 cases...

    The mention of reflectors on the V35 cases interested me. On all the rounded contour Givi/Kappa top cases I’ve used, their design incorporates large areas of red translucent plastic that one assumes...
  17. Replies
    1,354
    Views
    75,106

    Sticky: Congratulations on the mileage milestone! The...

    Congratulations on the mileage milestone! The funny thing is though, if this were my car, truck, or van at 75,000 miles, it would have just broken in it’s 2nd set of tires, and everything else would...
  18. Replies
    24
    Views
    857

    I try to buy from large Honda Powerhouse dealers...

    I try to buy from large Honda Powerhouse dealers who sell at a discounted price, no freight, no prep, no games. Sometimes they can get product on request from a Honda warehouse, and they often get in...
  19. Replies
    26
    Views
    527

    I haven’t seen the Shad side cases you...

    I haven’t seen the Shad side cases you specifically mentioned, but one thing I noted when Shad first came out with NC cases, was that the mounting hardware sat way out from the bike, making the...
  20. Replies
    4
    Views
    130

    Glad you introduced yourself! It sounds like the...

    Glad you introduced yourself! It sounds like the NC will be just perfect for your rides. May you have many happy miles!
  21. Replies
    14
    Views
    1,124

    I’m curious what your rotor thickness is at this...

    I’m curious what your rotor thickness is at this point, and how close it is to minimum spec.

    My fear with aftermarket low cost rotors is, will they warp when they get used hard? Then again, I...
  22. Replies
    118
    Views
    6,256

    On the other hand, take it as a compliment. I...

    On the other hand, take it as a compliment. I like scooters. We own three scooters. They're cool. There's nothing wrong with a "scooter motor". But, if the guy is just ignorant, well, the joke's...
  23. Replies
    24
    Views
    857

    Rember that the Honda accessories can be easily...

    Rember that the Honda accessories can be easily purchased for 20% more off of list price. I bought my Honda centerstand, MSRP $149, some years ago, but I paid $107, free shipping, no sales tax. I...
  24. Replies
    118
    Views
    6,256

    Maybe the guy was referring to the engine as...

    Maybe the guy was referring to the engine as being exactly like the one used in the Honda Integra “scooter”? Nah, probably not. I doubt he’d ever heard of the Integra.

    39424
  25. Thread: Shinko raven

    by 670cc
    Replies
    3
    Views
    126

    My NC700X currently has Shinko Raven 009s on...

    My NC700X currently has Shinko Raven 009s on front and rear. The rear has maybe 1500 miles on it so far, while the front is at 12,000 miles right now. The front probably has a couple thousand left in...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4