I searched google for the image and found https://www.amazon.co.uk/Blesiya-Mot...t=1&pldnSite=1
I then searched ebay for NC700 windscreen adjuster and got Motorcycle Windscreen Adjusters Windshield Bracket for HONDA NC700X 2012-2015 | eBay for a bit less money
15 450/520XCF SM
I had to trim 1" off each bottom lower edge of the screen so the Barkbuster skeleton wouldn't hit it. No problem, the shield was too wide at the bottom to begin with. A couple years later I added SW Motech 30mm risers with 20mm of pull back. If I had these on the bike when I added the Madstad the BBs wouldn't hit it with the rise and the pull back. They don't sell these risers anymore but there might be others like them.
In this picture off the Madstad web site you can project where the Barkbuster will touch the screen at full lock turned right, if they hit at all.. Because of the wide range of height adjustment the bars may clear the shield on certain bikes at certain adjustments and not on with others. I have a 20" normally set in the full down position. The Barkbusters hit the lower edges, the projections at the bottom corners of the current Madstad screen. (Originally on 1st gen screens those projections were not there) The pictured 2016-18 windshield it also fully down and if might clear with no trimming but if the shield was raised up it would hit.
I tried those adjustable brackets with the stock small windscreen and it made no difference. Still have them around here somewhere.