Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Windshield advice - NC750X for 5'7" 32 inseam rider

  1. #11

  2. #12
    Super Moderator Windshield advice - NC750X for 5'7" 32 inseam rider 670cc's Avatar
    Bike: NC700X, GL1800, KLX140G, CRF250L Rally, Ruckus 50
    Join Date
    Aug 2012
    Quote Originally Posted by SpecialAgentNancy View Post
    Following up....did you read my earlier post? If you have handguards you don't get full range of handlebar movement.

    Total cost for this experiment was $100. $20 shipping back AND 15% restocking fee of $70.
    Too bad the Madstad didn’t work out for you. Oh, well.

    A common solution to the shield/bar interference problem is bar risers. Many people have the risers installed to improve comfort anyway. I have 2 inch risers, the Madstad, and handguards, and have no interference issues.
    GWRRA Member
    AMA Life Member
    "240,000 Mile Club"

    NanCyX . . . . . . . . . . The 250

  3. #13
    Senior Member Windshield advice - NC750X for 5'7" 32 inseam rider dduelin's Avatar
    Bike: NC700XD, ST1300, Elite 80
    Join Date
    Jul 2012
    North FL USA
    2015 NC700X DCT. I have Barkbuster Storms and a Madstad with winglets and aside from having to trim a bit off each side of the shield there is no interference with the windshield or winglets. I do have risers but I did not have risers when the Madstad was first installed.

    Sorry it did not work out for you on a 750X. There is a lot of adjustment to the fit of the system and the winglets. Did you try changing things around?


Similar Threads

  1. First impressions: new Madstad 20" windshield
    By GoRovers in forum NC700 Mods
    Replies: 57
    Last Post: 22nd February 2019, 23:16
  2. Taking my NC750x to IOM TT - any advice ?
    By pomfreti in forum The Bar
    Replies: 12
    Last Post: 21st May 2015, 16:50
  3. Inseam-Challenged New Rider Looking for Advice
    By Mitu in forum NC700 General Discussion
    Replies: 16
    Last Post: 28th February 2015, 12:59
  4. Replies: 10
    Last Post: 18th January 2015, 19:02
  5. Replies: 1
    Last Post: 5th October 2013, 22:21

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts