Been wondering if anybody can help.
Gave the bike (NC700X, 2012) a wash today.
Nothing fancy (no pressure washer, etc.), just hosed it down, sprayed with MucOff, cleaned with sponge and rinsed it off with a hose again.
Ever since then the ABS warning light stayed on. Took both sensors off, cleaned them, put them back on ... still on after 6 mph.
Cleaned the rear and front pulser ring ... still won't go off once I go past 6 mph.
Anybody any idea what the problem is?
HI, did you get this figured out? The 2012 ABS system has a diagnostic mode that can be initiated by shorting the DLC terminal above the battery. Take a minute to read up on it. You can then count the flashes and look up the corresponding code.