Pianoman
Member
- Joined
- Dec 24, 2014
- Messages
- 51
- Reaction score
- 4
- Points
- 8
- Location
- Charneca da Caparica, Portugal
I felt the need to push the top box a little bit further back for two reasons:
First: little space for pillion
Second: the pillion seat wasn't able to open completely due to the use of a lower back cushion in the top case (bad planning by Honda!)
So...the answer was to have a iron plate done to install the top box some 5 or 6 cm back. The difference is great!
Curiosidades #9_REAR CARRIER BRACKET EXTENSION (for HONDA NC750X) - YouTube
Please subscribe my channel here: Pianoman PT
- YouTube
THANKS!
First: little space for pillion
Second: the pillion seat wasn't able to open completely due to the use of a lower back cushion in the top case (bad planning by Honda!)
So...the answer was to have a iron plate done to install the top box some 5 or 6 cm back. The difference is great!
Curiosidades #9_REAR CARRIER BRACKET EXTENSION (for HONDA NC750X) - YouTube
Please subscribe my channel here: Pianoman PT
- YouTube
THANKS!